Tie the pleasure craft securely to the fuel dock. Whenever you start your boat after it has been sitting idle for some time.
Check for fumes and inspect for water oil and fuel leaks.
What should you do after fueling your boat and before starting the engine?. If by any chance any flammable gases have collected inside your boat the blower will exhaust them out. This ensures all gasoline fumes have been removed before ignition. If you smell fumes increase air circulation to clear them.
Before beginning to fuel. Check to see that fuel lines connections and fuel vents are in good condition. If you want to make the switch to ethanol gasoline there are a few things you should do beforehand.
What is the best way to check for gas fumes after fueling a PWC. If they have not no harm is done. Shut OFF the engine.
O Before starting the engine run the blower for at least four minutes and check the bilge for any fuel vapors. Check to see that fuel lines connections and fuel vents are in good condition. Open all windows ports doors and other openings.
An owners or service manual should be consulted for the locations. Following the refueling operation open up the boat and ventilate all spaces especially the bilges and engine compartment. Turn ON the ventilation system.
Tie the boat securely to the fuel dock. Ethanol is a type of solvent that you are introducing into your boat. OPEN all windows ports doors and other openings.
If your boat does not start after allowing it to prime make sure fuel is getting to the engine and that the primer is not damaged. Let the engine run slightly above idle for several minutes then gradually raise the throttle. In fact after refueling you shouldnt smoke because the fuel vapour can arouse inflammation.
For vessels with an inboard engine use the powered ventilation system to blow away any residual fumes that may have built up in the bilge. This will help eliminate fuel vapours in the bilge. After fueling check for the smell any fumes before starting the boats engine again.
Turn off the engine and electronic devices. You should turn off the bilge blower and close doors windows and hatches before fueling. If your pleasure craft is equipped with a power ventilation system exhaust blower turn it on for at least four minutes before starting your engine.
If your boat has an electric primer check that fuel is flowing correctly by removing one of the fuel hoses that connect the primer to the carburetor or engine intake. Powered ventilation systems are required on boats built after 1982 with installed fuel tanks or an enclosed engine. Its important to note that boats with powered ventilation systems should be turned on and let it run for four full minutes before starting the engine.
Before starting the engine again take a good sniff to see if any fumes have escaped. OPEN all windows and hatches. Turn the key and wait until the engine catches and runs.
If you have an inboard gasoline engine you need to turn on the blower for four full minutes before starting your boat. It is also best to fuel your boat on a ramp rather than in the. Shut OFF the engine.
What should you do after fueling your boat and before starting the engine. That way fumes cannot enter the boat as easily. As a result it tends to loosen debris that has built up inside the tank and the fuel system.
Inspecting the engine compartment is a must before turning the key for the first time after a long winter. If your boat is equipped with a power ventilation system exhaust blower turn it on for at least four minutes before starting your engine. If your boat has a blower run the blower for a few minutes before starting the engine.
Do not allow anyone in your group or others at the fuel dock to smoke strike a match or use a lighter. Do not allow anyone in your group or others at the fuel dock to smoke or strike a match. After fueling be sure to secure the filler cap to prevent fuel from leaking or water from entering the tank.
Do the sniff test. Ask all passengers to leave the boat and go onto the dock. If you smell fumes increase air circulation to the area and wait until the fumes have fully dissipated before turning on the engine.
Starting the engine and pulling away from the dock. This is a basic safety precaution. CLOSE all windows ports doors and other openings.
Before you start fueling the boat shut off all the door windows and other openings of your boat so that the fuel fumes cant enter into the boat. This can in turn clog your fuel line or even the engine. Open all windows ports doors and other openings.
Before you begin fueling your boat you should make sure your fire extinguisher is within reach. Open all ports hatches and doors to ventilate. Youll need to check engine oil level inspect the bilge area for fluid leaks.
If the engine runs smoothly without missing you can launch. You should turn your blower on before starting the engine. Put the fill cap on tightly to prevent vapors from escaping.
Make certain the boat has been placed in the water so the intake water pump can pick up cooling water. Wipe up any spilled fuel and properly dispose of the used paper towels or rags on shore. Ask all passengers to leave the pleasure craft and go onto the dock.
Next go to the engine room or compartment.